Wireless Remote Receiver for the Revox A700
Last updated February 2, 2019
Ready
to ship
I sell this on eBay for $85 or buy direct for $80 + shipping of $10 within the US or $23 outside.
Contact me at scott@revoxremotes.com
This unit controls the standard transport controls on the Revox A700 deck (Play, Record, Stop, Fast Forward and Rewind). It uses any standard universal remote programmed for Sony VCR (preprogrammed DirecTV remote included).
The remote adapter can be programmed to respond to various Sony VCR codes. To select between them there are jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover. Located near the front window is a jumper block. These jumpers configure what type of Sony VCR codes the unit will respond to. See the table below for a list of jumper settings.
JMP1
|
JMP2 |
Device
Type |
RCA Remote |
DirecTV |
JMP
|
JMP |
Beta VCR
|
VCR-119 |
20033 |
JMP
|
OPEN
|
8mm VCR
|
VCR-098
|
20034 |
OPEN
|
JMP
|
VHS VCR
|
VCR-099
|
20032 |
OPEN
|
OPEN |
LDP
|
---- |
---- |
LDP = Laser Disc Player
Configuring the DirecTV Remote
To program the DirecTV Remote first slide the switch at the top of AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5 digit code from the table above. If done correctly the green light will blink twice after the last digit is entered. Note: On the remote the Record button must be double pressed to activate the function. The full manual for the remote can be found here.
Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.