Teac RC-80 Wireless Remote Adapter
I sell this on eBay for $74 or buy direct for $69 + shipping of $10 within the US or $25 to the rest of the world.
Contact me at scott@revoxremotes.com
Installation: Turn off the power to the tape deck. Plug the remote adapter into the remote connector on the back of the tape deck. Now power can be turned back on. The light on the front of the remote adapter should be on.
The remote adapter controls the following 7 functions: Forward Play, Reverse Play, Fast Forward, Rewind, Pause, Stop and Record. All functions can be controlled using any universal remote programmed for the proper Sony VCR code.
The remote adapter can be programed to respond to Sony VHS VCR, Beta VCR, 8mm VCR and Laser Disc Player codes. To select between the four options there are two jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover.
Toward the front window are two jumpers labeled 1 and 2. They configure the remote device code per the table below.
|
JMP1
|
JMP2 |
Device |
DirecTV
Remote |
|
JMP*
|
JMP* |
Beta |
20033
|
|
JMP
|
OPEN
|
8mm
VCR |
20034 |
|
OPEN
|
JMP
|
VHS
VCR |
20032 |
|
OPEN
|
OPEN |
LDP |
---- |
* = Default jumper selection
Configuring the DirecTV Remote: To program the remote first slide the switch at the top to AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5 digit device code from the table above. If done correctly the green light will blink twice after the last digit is entered. The full manual for the DirecTV can be found here
For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here