Wireless Luxman AK-20 (AK-10) Remote
Wireless Alpine RU-20 Remote
Updated June 24, 2021
Works with the Luxman K-03, K-04, K-05, K-240, K-260, K-405, K-406 cassette decks
and also with Alpine AL-85, AL-90 cassette decks
Plugs into the 8-pin DIN connector on the back of the deck. Controls Play, Stop, Fast Forward, Rewind, Record, Pause and Record Mute.
Current price for this remote receiver, universal remote and international AC adapter is $74 plus shipping of $10 within the US and $25 outside the US.
If you would rather buy through eBay I have this listed for $79 in eBay listing
Contact me if you are interested. My email address is scott@revoxremotes.com
Installation: Turn off the power to the tape deck. Plug the remote adapter into the remote connector on the top or back of the tape deck. Now power can be turned back on. The light on the front of the remote adapter should be on.
The remote adapter controls the standard 7 transport functions: Play, Stop, Fast Forward, Rewind, Record, Pause and Record Mute. All functions can be controlled using any universal remote programmed for the proper Sony VCR code. Record Mute is controlled via the #0 button on the remote keypad.
The remote adapter can be programmed to respond to Sony VHS VCR, Beta VCR, 8mm VCR and Laser Disc Player codes. To select between the four options there are two jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover.
Toward the front window are two jumpers labeled 1 and 2. They configure the remote device code per the table below.
JMP1
|
JMP2 |
Device Code |
DirecTV
|
RCA Remote |
JMP
|
JMP |
Beta VCR |
20033
|
VCR-119 |
JMP
|
OPEN
|
8mm VCR
|
20034 | VCR-098 |
OPEN
|
JMP
|
VHS VCR
|
20032 | VCR-099 |
OPEN
|
OPEN |
LDP |
---- | ---- |
JMP1 and JMP2 are JMP by default
Configuring the RCA Universal Remote
To program the RCA remote press and hold the Code Search button until the
red light comes on. Release the Code Search button and momentarily press the
VCR button then enter the 3 digit code from the table above (default is 119).
The red light should blink after each keypress and go out after the last digit
is entered. Press the VCR button and press one of the transport control buttons
(PLAY, STOP, FF, REW, REC or PAUSE). The light on the front of the remote
adapter should blink off momentarily. If the light does not blink off try
reprogramming the remote or check the state of the jumpers inside the remote
adapter. On the RCA remotes the REC button needs to be pressed twice to
activate record.
Configuring the DirecTV Universal Remote
To program the DirecTV remote first slide the switch at the top to AV1 or
AV2. Press and hold the MUTE and SELECT buttons until the green light at the
top blinks twice then release. Using the number keypad enter the 5 digit device
code from the table above. If done correctly the green light will blink twice
after the last digit is entered. On this remote Record must be pressed twice to
activate. The full manual for the DirecTV remote can be found here.
For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here
If interested contact me at scott@revoxremotes.com
Wireless remote adapters are available for the following makes