Wireless Remote Receiver Tandberg RC 900
for Tandberg TCD 900 and TCD 910 tape decks

Last updated June 30, 2021

I sell this on eBay for $75 or buy direct for $70 + shipping of $10 within the US or $25 outside.

Contact me at scott@revoxremotes.com

universal remote and receiver with male 25-pin D-sub connector

This unit controls the standard transport controls on the Tandberg decks (Play, Record, Stop, Fast Forward and Rewind). It uses any standard universal remote programmed to control a Sony VCR (preprogrammed universal remote included).

Installation
Turn off the power to the tape deck. Plug the remote adapter into the male 25-pin D-sub remote connector on the back of the TCD 900 or TCD 910 tape deck. Now power can be turned back on. The light on the front of the remote adapter should be on. The remote adapter does not need any external power. It gets its power from the deck.

The remote adapter controls the standard 5 transport functions: Play, Stop, F.F., Rewind and Record. It can be used with any universal remote programmed for the proper Sony VCR code. On the supplied DirecTV remote REC must be double pressed before Record is activated on the deck.

The remote adapter can be programmed to respond to various Sony VCR codes. To select between them there are jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover. Located near the front window is a jumper block with three jumpers. The first two jumpers configure what type of Sony VCR codes the unit will respond to. See the table below for a list of jumper settings.

JMP1

JMP2

Device

DirecTV

JMP

JMP

Beta VCR

20033

JMP
OPEN
8mm VCR
20034
OPEN
JMP
VHS VCR
20032
OPEN

OPEN

LDP

----

LDP = Laser Disc Player

Configuring the RCA Universal Remote
To program the RCA remote press and hold the Code Search button until the red light comes on. Release the Code Search button and momentarily press the VCR button then enter the 3 digit code from the table above (default is 119). The red light should blink after each keypress and go out after the last digit is entered. Press the VCR button and press one of the transport control buttons (PLAY, STOP, FF, REW or REC). The light on the front of the remote adapter should blink off momentarily. If the light does not blink off try reprogramming the remote using the next setting in the table or check the state of the jumper inside the unit and match that to the correct line in the table. On the RCA remotes the REC button needs to be pressed twice to activate record.

Configuring the DirecTV Remote
To program the DirecTV remote first slide the switch at the top of AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5 digit code from the table above. If done correctly the green light will blink twice after the last digit is entered. Note: On the DirecTV remote the Record button must be double pressed to activate the function. The full manual for the remote can be found here

For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here

Contact me if you are interested. My email address is scott@revoxremotes.com

Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Luxman, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.