Teac RC-120 Wireless Remote Adapter

Works with: Teac A-2300SD, A-2300SX, A-2340SX, A-3300S, A-3300SX, A-3340S and A-6100

Buy direct for $120 plus shipping of $8 within the US or $23 outside the US.

Contact me at scott@revoxremotes.com
scott@revoxremotes.com is also my PayPal account

Installation: Turn off the power to the tape deck. Plug the remote adapter into the remote connector on the back of the tape deck. Now power can be turned back on. The light on the front of the remote adapter should be on.

The remote adapter controls the standard 6 transport functions: Play, Stop, F.F., Rewind, Record and Pause. All functions can be controlled using any universal remote programmed for the proper Sony VCR code.

The remote adapter can be programed to respond to Sony VHS VCR, Beta VCR, 8mm VCR and Laser Disc Player codes. To select between the four options there are two jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover.

Toward the front window are two jumpers labeled 1 and 2. They configure the remote device code per the table below.



Device Code

DirecTV Remote



Beta VCR

20033 *

8mm VCR




* = Default jumper selection


Configuring the DirecTV Remote: To program the remote first slide the switch at the top to AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5 digit device code from the table above. If done correctly the green light will blink twice after the last digit is entered. The full manual for the DirecTV can be found here: www.revoxremotes.com/Remotes/DirecTV.htm

For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here

Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.