Instructions for setting up the

Philips PH5DSS

5 Component Universal Remote Control

1) Find the Component Code number for the desired Device from the table below.

 

2) On the remote press and hold the CODE SEARCH button until the red light comes on and stays on. Now release the button. (The CODE SEARCH button is located 2nd row from the bottom and 2nd from the left.)

3) Press and release the VCR button.

4) Now enter the four digit Component Code on the remotes number pad.

If the red light goes out the VCR preset should now be set. If the red light will flash three times the code was not accepted.

 

The full instruction manual for this remote is located here --> Philips PH5DSS Manual

The complete list of Component Codes for this remote is located here --> Philips PH5DSS Codes