Instructions for setting up the
One For All URC3021
3 Component Universal Remote Control
1) Find the Code that matches the jumper setting in the remote receiver. Most of the time it will be the first line (JMP, JMP).
Use the following table if controlling a tape deck
JMP1 |
JMP2 |
Code |
Device Type |
JMP |
JMP |
0033 |
Beta VCR |
JMP |
OPEN |
---- |
8mm VCR |
OPEN |
JMP |
0032 or 1232 |
VHS VCR |
OPEN |
OPEN |
---- |
LDP |
Default jumper setting is JMP1 and JMP2 = JMP
Use the following table if controlling a disc player or recorder
JMP1 |
JMP2 |
Code |
JMP |
JMP |
? |
JMP |
OPEN |
? |
OPEN |
JMP |
? |
OPEN |
OPEN |
? |
Default jumper setting is JMP1 and JMP2 = JMP
2) Press and release the DVD/VCR button.
3) On the One For All remote press and hold the SET button until the red light blinks twice, then release.
4) Enter the four digit Component Code on the remotes number pad. If done correctly the red light should blink twice on the last digit. If done incorrectly the red light will flash only once on the last digit.
The DVD/VCR preset should now be set.
The full instruction manual for this remote located here --> One For All URC3021 Manual
The complete Code list for this remote is located here --> One For All URC3021 Codes